The script is located on the SD card of the Taranis. The Micro TX can be configured using a LUA script. Use the LUA script from the following part (Micro TX configuration) or the OLED display of the large Crossfire module. The Micro RX must also be configured as follows. Here is a photo from the model settings for a Crossfire system. The Crossfire TX module must also be connected to the Taranis in CRSF mode. The Micro RX must be successfully bound via the CRSF protocol. Here you can find examples of the connection to: The Crossfire RX is connected to flight controls with Betaflight Firmware via a UART. TBS Agent (Windows GUI for flashing/updating the Crossfire TX)īelow is the procedure for configuring the Crossfire system on Betaflight flight controls.OpenTx Firmware (+ latest SD Card Files).Crossfire Configuration LUA Scripts (are always located in the SD card files of the current OpenTX version).Crossfire TX module must be controlled via CRSF protocol (Taranis).Micro RX must be bound with Crossfire TX.OpenTX 2.1 or higher (IMPORTANT: Always install the appropriate SD card files).KISS FC V2 on version 1.3 RC32s or higher.KISS FC V1/CC on version 1.3 RC30 or higher.TBS Crossfire TX module and RX on version 1.62 or higher.
